AK088xAS Adjustable Depth Liners
WARNING:
When building a custom hood for a power pack, always follow all applicable construction codes and standards.
See the illustrations and table below to locate your liner choice and use corresponding custom hood
base dimensions. For the liner installation, only the bottom of the custom hood is needed. Do not
finalize the entire custom hood yet, because an opening is needed for the power pack.
Recommended
thickness:
3/4''
B
2 1/16''
A
Plywood base thickness: 3/4”
FIG 1
*Inside
*Inside Depth (B)
Power Pack Custom Hood
Liner
Model
Exterior Width
Model
Width (A)
Without Backboard **With Backboard
20 1/2” - 23 1/2” 20 1/8” - 23 1/8”
20 1/2” - 23 1/2” 20 1/8” - 23 1/8”
20 1/2” - 23 1/2” 20 1/8” - 23 1/8”
20 1/2” - 23 1/2” 20 1/8” - 23 1/8”
20 1/2” - 23 1/2” 20 1/8” - 23 1/8”
AK8800AS
AK8800AS
AK0886AS
AK0882AS
AK0888AS
AK0884AS
AK0880AS
36 inches
42 inches
48 inches
54 inches
60 inches
34 1/2”
40 1/2”
46 1/2”
52 1/2”
58 1/2”
AK8800AS
AK8800AS
AK8800AS
*Dimension does not include 3/8” wide flange around liner.
**The inside depth shown in the table above assumes a minimum cabinet backboard thickness of 3/8”.
FIG 1:
Zephyr recommends the base of the custom hood to be 3/4” thick plywood. The sides,
front and backboard (if included) of the custom hood to be 3/4” thick, assuming standard
cabinet widths.
Consider the shape and size of the power pack to determine the configuration of the custom hood.
For more details, refer to the installation manual of the power pack.
Zephyr Corporation
2277 Harbor Bay Pkwy, Alameda, CA 94502
Tel: 1.888.880.8368 Fax: 1.888.990.8368
e-mail: [email protected]
SEP08.0101
1
|